J Ect Solenoid No Circuit with ECT

HINT: While carrying out the following inspection, make certain that the connectors and terminals are properly connected.

INSPECT SYSTEM

Is ECT system normal?

CC ECU

Yes

Disconnect connector from CC ECU and inspect connector on wire harness side as follows.

INSPECT NO. 2 SOLENOID CIRCUIT

Is there approx. 13Q between terminal 9 and ground?

Yes

Replace CC ECU. Then recheck system.

Repair ECT system. Then recheck system.

Open or short circuit in wire harness between terminal 9 of CC ECU and No. 2 solenoid.

CC: Cruise Control

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment