Removal Of Outside Moulding

(see page BO-25) 1. REMOVE ENDS OF MOULDING

Using a scraper, pry the moulding loose about 30 mm

HINT: Tape the scraper tip before use.

2. REMOVE MOULDING AND ADHESIVE

(a) Pull off the moulding by cutting the adhesive with a knife.

(b) Scrape off adhesive from the body with a cutter of sandpa per.

NOTICE:

• Remember that 30 - 80 mm (1.18 - 3.15 in.) of the ends of the moulding are glued tightly with a strong adhesive.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment