Remove Center Cluster Finish Panel Radio And Lower Center Finish Panel

(a) Remove two screws.

(b) Using the screwdriver, remove the center cluster finish pan el and disconnect the connector.

(c) Remove four screws from the radio.

(d) Disconnect the connectors and the radio antenna cable to remove the radio.

(e) Using the screwdriver, remove screw caps.

(f) Remove four screws and the panel.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment