In the following cases, replace the wire harness or connector.
• If any part of the airbag system wire harness or any connector has been found to be faulty in troubleshooting.
• If any part of the airbag system wire harness or any connector has been found to be faulty during the check in item 2. - (b) or (c).
NOTICE: If the wire harness used in the airbag system is damaged, replace the whole wire harness assembly.
When the connector to the front airbag sensors can be repaired alone (when there is no damage to the wire harness), use the repair wire specially designed for the purpose (See page AB-21).
Was this article helpful?
You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.