Antenna Motor Control Relay

INSPECTION OF ANTENNA MOTOR CONTROL RELAY

1. INSPECT RELAY OPERATION (ANTENNA UP)

(a) Connect the voltmeter positive (♦) lead to terminal 1 and the negative (-) lead to terminal 4.

(b) Connect the positive (+) lead from the battery to terminals 7 and 8. Connect the negative (-) lead to terminal 3.

(c) Check that there is battery voltage.

2. INSPECT RELAY OPERATION {ANTENNA DOWN)

(a) Connect the voltmeter positive (+) lead to terminal 4 and the negative (-) lead to terminal 1.

(b) Connect the positive (+) lead from the battery to terminal 7. Connect the negative (—) lead to terminal

(c) Check that there is battery voltage.

3. INSPECT RELAY OPERATION (ANTENNA STOP)

(a) Connect the voltmeter positive (♦) lead to terminal 1 and the negative (—) lead to terminal 4.

(b) Connect the positive (+) lead from the battery to terminals 7 and 9. Connect the negative (-) lead to terminal 2.

(c) Check that there is no battery voltage.

If operation is not as specified, replace the relay.

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment