1. APPLY LITHIUM SOAP BASE GLYCOL GREASE TO FOLLOWING PARTS:
(a) Main pin boot
(b) Sliding pin and boot
(c) Piston seal and piston
2. INSTALL PISTON SEAL AND PISTON IN CYLINDER
3. INSTALL CYLINDER BOOT AND SET RING IN CYLINDER
SEE REAR BRAKE REPLACEMENT OF BRAKE PADS BR-20
4. INSTALL MAIN PIN BOOT
Using a 21-mm socket wrench, press in the boot.
5. INSTALL DUST BOOT AND SLIDING BUSHING
(a) Install the dust boot.
NOTE: Be careful that the seal does not fold under.
(b) Install the bushing into the boot facing the flange toward the inside.
Was this article helpful?