Assembly Of Lower Valve Body

1. INSERT PRIMARY REGULATOR VALVE AND SPRING

(a) Set the valve body on the edge and drop in the valve, large end first, and the spring.

(b) Make sure that the primary regulator valve fits flush with the valve body.

(c) Insert with the rounded end first. Make sure that it is fully inserted; the plunger should be recessed inside the sleeve.

(d) Insert the sleeve with the plunger.

(e) Install the regulator valve sleeve retainer.

(f) Install the retainer on the bevel.

NOTE: Install the retainer to the same position of the sleeve, as when disassembling.

2. INSTALL LOCK-UP RELAY VALVE

(a) Install the lock-up relay valve into the sleeve.

(b) Install the spring into the lock-up relay valve.

(c) Install the lock-up relay valve assembly into the bore.

ATOtOO

(d) Install the pin.

ATOtOO

3. INSTALL NO.3 SOLENOID

(a) Install the No. 3 solenoid onto the lower valve body.

(b) Temporarily tighten the bolt.

4. INSTALL TWO VALVES

(a) Install the low coast modulator valve into the bore.

(b) Install the intermediate modulator valve into the bore.

5. INSTALL TWO VALVE SPRINGS

NOTE: Install the short spring in the right bore.

C44W

6. INSTALL NO.1 AND NO.2 SOLENOIDS

Install the solenoid over the gasket. Tighten the three bolts.

C44W

7. INSTALL PRESSURE RELIEF VALVE

(a) Place the steel ball and spring onto the body.

(b) Install the retainer.

8. INSTALL TWO VALVE BODY COVERS

NOTE: Use the wave washer for the smaller cover.

9. CHECK RETAINERS AND LOCATING PINS

Make sure that the retainers and pins are installed correctly.

10. INSTALL SPRINGS, DAMPING CHECK BALL, COOLER RETURN CHECK BALL AND COOLER BY PASS CHECK VALVE

11. INSTALL LOWER VALVE BODY GASKET

Note that the two gaskets are not interchangeable. The gasket must lay flat on the valve body.

12. INSTALL LOWER VALVE BODY PLATE

Set the plate into place. Temporarily install two the short bolts finger tight to compress the plate against the spring-loaded check valve.

NOTE: Use the oil strainer bolts.

Cooler 8y-pass Oamping Check Ball

~ Return

Check Ball

(Upper Front Valve Body)

Retainer -

Cut-back Valve

Plug

Throttle Cam

Retainer

Mail 11 fin

Adjusting Ring

Cover iiu|uuumi|i minnivmun

Throttle Cam

Retainer

Adjusting Ring

Q— Sleeve

mmmr a

Down shift Plug

Secondary Regulator Valve

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment