Assembly Of Upper Rear Valve Body

1. INSTALL 3-4 SHIFT VALVE

(a) Install the 3-4 shift valve and spring.

(b) Install the plug into the bore. Coat the retainer with petroleum jelly and install it.

2. INSTALL 1-2 SHIFT VALVE

(a) Install the 1-2 shift valve and spring.

(b) Install the plate over the gasket. Torque: 55 kg-cm (48 in.-lb, 5.4 N-m)

3. INSTALL 2-3 SHIFT VALVE

(a) Install the 2-3 shift valve and spring.

(b) Install the plug into the bore.

(c) Coat the retainer with petroleum jelly and install it.

4. INSERT REAR CLUTCH SEQUENCE VALVE

(a) Install the valve spring, and the valve.

(b) Install the plug into the bore.

(c) Coat the pin with petroleum jelly and install it.

5. INSTALL CHECK BALLS AS SHOWN

Install the six steel balls in the position shown in the figure.

C4437 C44*

atc«io

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment