Automatic Temperature Control

ON-VEHICLE INSPECTION

1. REMOVE COMPONENTS FROM VEHICLE

(a) Undercover

(b) Center cluster

Temperature Control Lever

Air Flow Control Lever

"n«l| I HI I I IM llltMTTW • 1 I »1 I if r-rut« qp v i "^'ftr-n»

Blower

Control Lever

Air Intake i

Control Lever p

2. RECONNECT TO CHECK CONNECTOR

3. PLACE TEMPERATURE CONTROL LEVER AT 77

4. RUN ENGINE AT IDLING

WUHfifi

5. CHECK AUTOMATIC TEMPERATURE CONTROL

(a) Verify that the white line marked on the stem is positioned within the orange area on the power servo unit.

(b) If the white line positions are not in the orange area, adjust as follows:

ADJUST AUTOMATIC TEMPERATURE CONTROL

(a) Normally the orange adjusting terminal is connected.

(b) If the white line on the stem is in the red area, change the connection to the red adjusting terminal.

(c) If the white line is within the white area, change the connection to the white adjusting terminal.

REINSTALL REMOVED PARTS IN REVERSE ORDER

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment