REMOVAL OF BACK DOOR GLASS
1. REMOVE REAR SPOILER
(a) Remove the back door trim.
(b) Remove the eight nuts.
(c) Disconnect the high mount stop light wire connector.
(d) Lift up the rear end of the spoiler, slide it toward the front, and remove it.
(e) Remove the four clips from the spoiler.
REMOVE FOLLOWING PARTS:
(a) Rear wiper arm
(b) Window defogger wire connector
3. REMOVE GLASS
(a) If reusing the weatherstrip:
Working from the vehicle outside with a screwdriver, loosen the weatherstrip lip from the body.
(b) If not reusing the weatherstrip:
From the outside, cut off the weatherstrip lip with a knife.
(c) Force the weatherstrip lip from the interior to the body flange outside. Pull the glass outwards and remove it with the weatherstrip.
INSTALLATION OF REAR WINDOW
1. CLEAN BODY AND GLASS
Wipe off any adhesive left on the body or glass with alcohol.
2. INSTALL WEATHERSTRIP ON GLASS
(a) Attach the weatherstrip to the glass.
CAUTION: If the weatherstrip has hardened, it may develop water leaks. Use a new one if possible.
(b) Apply a working cord along the weatherstrip groove as shown.
3. INSTALL GLASS
(a) Apply soapy water to the contact face of the weatherstrip lip and to the body flange.
NOTE: Begin installation ¡n the middle of the lower part of the glass.
(b) Hold the glass in position on the body.
(c) Install the glass by pulling the working cord from the interior, while pushing the outside of the weatherstrip with your open hand.
(d) To snug the glass in place, tap from the outside with your open hand.
4. APPLY ADHESIVE
(a) Put masking tape around the weatherstrip to protect the paint and glass.
(b) Apply adhesive between the weatherstrip and glass and between the weatherstrip and body.
Part No. 08833 00030 or equivalent
NOTE: When adhesive is dry, remove the masking tape.
5. INSTALL FOLLOWING PARTS:
(a) Window defogger wire connector
(b) Rear wiper arm
6. INSTALL REAR SPOILER
(a) Install the four clips to the spoiler.
(b) Install the spoiler to the back door.
(c) Connect the high mount stop light wire connector.
(d) Tighten the eight nuts.
(e) Install the back door trim.
Was this article helpful?