(See page EM18)
1. REMOVE CYLINDER HEAD COVERS
Remove the two cylinder head covers by loosening the screws.
2. REMOVE NO. 1 AND NO. 2 CAMSHAFT HOUSINGS WITH CAMSHAFT
Remove No. 1 and No. 2 camshaft housings by loosening the nuts (front side) and bolts.
CAUTION: Loosen each camshaft housing nut and bolt a little at a time In the sequence shown in the figure.
3. REMOVE ROCKER ARMS AND LASH ADJUSTERS
Remove the rocker arms and lash adjusters from the cylinder head.
NOTE: Arrange the rocker arms and lash adjusters in order.
(a) Using SST, compress the valve spring until the two keepers can be removed.
(b) Remove the valve keepers, retainers, springs and valves.
NOTE: Keep valves in order for reinstallation in the same manner.
(c) Remove the valve stem oil seals.
(d) Using a small screwdriver or magnet, remove the valve spring seats.
Was this article helpful?