Disassembly Of Front Clutch

1. REMOVE THRUST BEARINGS AND RACES FROM BOTH SIDES OF CLUTCH

Note the position of the races.

2. USE EXTENSION HOUSING AS WORK STAND

3. REMOVE SNAP RING FROM FRONT CLUTCH DRUM

4. REMOVE FRONT AND REAR CLUTCH HUB

Lift out the two clutch hubs together.

REMOVE THRUST BEARING AND RACES

Note the position of the races.

REMOVE DISC

REMOVE THINNER SNAP RING

REMOVE REMAINING CLUTCH PLATES AND DISCS

9. COMPRESS PISTON RETURN SPRINGS AND REMOVE SNAP RING

Place SST on the spring retainer and compress the springs with a shop press.

Remove the snap ring with a screwdriver. SST 09350-20013 (09369-20040)

10. REMOVE SPRING RETAINER AND EIGHTEEN SPRINGS

11. ASSEMBLE FRONT CLUTCH ON OVERDRIVE CASE ANO BLOW OUT PISTON

(a) Slide the front clutch onto the overdrive case.

(b) Apply compressed air to the overdrive case to remove the piston. (If the piston does not come out, use pliers to remove it.)

(c) Remove the front clutch from the overdrive case.

12. REMOVE O-RINGS FROM PISTON

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment