Front Brake

COMPONENTS

Corolla 2002 Squeaking Front Brake Pads

REPLACEMENT OF BRAKE PADS

NOTE: If a squealing noise occurs from the brakes while driving, check the pad wear indicator. If there are traca of the indicator contacting the rotor disc, the disc paj should be replaced.

—Torque Plate

Main Pin Boot kfl-cm (ft-lb, N»m) : Specified torque

Oise Brake Cylinder-

Cylinder Installation Bolt [ 200 (14, 20)

Anti-Squeal

Pad Guide Plate Anti-Rattle Spring

Pad Support

Pad Guide Plate -Anti-Rattle Spring -

1. DRAW OUT A SMALL AMOUNT OF BRAKE FLUID

2. REMOVE CYLINDER INSTALLATION BOLT

3. LIFT UP CYLINDER

(a) Lift up the cylinder.

(b) Insert a bolt into the torque plate hole to secure the cylinder.

4. REMOVE PADS AND ANTI-SQUEAL SHIM

5. REMOVE ANTI-RATTLE SPRINGS, PAD GUIDE PLATES AND SUPPORT PLATE

Anti Squeal Shims 2007 Camry

6. INSTALL NEW PAD SUPPORT PLATE. NEW PAD GUIDE PLATES AND NEW ANTI-RATTLE SPRINGS

7. PUSH PISTON INTO CYLINDER

8. INSTALL NEW PADS AND NEW ANTI-SQUEAL SHIM

(a) Install the pads onto each spring.

NOTE: Install the outside pad so the wear indicator is at the top side.

CAUTION: Do not allow oil or grease to touch the rubbing face.

(b) Install the anti-squeal shim toward the inside of the pad.

9. LOWER CYLINDER

Remove the bolt from the torque plate and lower the cylinder.

NOTE: Insert the cylinder carefully so the boot is not wedged.

10. INSTALL CYLINDER INSTALLATION BOLT

Install and torque the cylinder installation bolt. Torque: 200 kg-cm (14 ft-lb, 20 Nm)

11. FILL BRAKE FLUID

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment