Front Lower Frame
Door Belt Moulding
Inside Handle Bezel
Rear View Mirror
Upper Front Garnish
DISASSEMBLY OF FRONT DOOR
1. REMOVE DOOR TRIM
(a) Remove the courtesy light.
(b) Remove four bolts holding the door trim to the front door.
(c) Insert a screwdriver between the retainers and the door panel to pry it loose.
(d) Disconnect the wiring connector and remove the door trim.
(e) Remove the upper door trim.
(f) Remove the upper front garnish.
2. REMOVE SERVICE HOLE COVER
REMOVE REAR VIEW MIRROR
(a) Remove the cover.
(b) Disconnect the wiring connector.
(c) Remove the three set screws and mirror.
REMOVE BELT MOULDING
(a) Remove the top of the weatherstrip near the glass on both sides of the door.
(b) Remove the two set screws, and pry loose the retainers with a scraper to remove the belt moulding.
REMOVE DOOR GLASS
(a) Remove the upper stopper, trim support and inner stabilizer.
(b) Raise the window up 20 - 40 mm (0.79 - 1.57 in.).
(c) Remove the two guide set bolts.
(d) Remove the door glass by pulling it upward.
(e) Remove the glass guide and front lower frame.
REMOVE REGULATOR WITH POWER WINDOW MOTOR
(a) Disconnect the wiring connector.
(b) Remove the regulator mounting bolts.
(c) Remove the regulator with the power window motor through the service hole.
DISCONNECT FOLLOWING LINKAGES:
(a) Door opening control link
(b) Door lock control link
(c) Door lock cylinder link
(d) Outside control link
REMOVE INSIDE HANDLE REMOVE OUTSIDE HANDLE
10. REMOVE DOOR LOCK AND SOLENOID
Bolt 3 ^Stopper
Was this article helpful?