Inspection Of Fadeout Relay

1. INSPECT COURTESY SWITCH CIRCUIT OPERATION

Connect the positive (♦) lead from the battery to terminal 2. Connect the negative (—) lead to terminals 1 and 6. Connect a 3.4W test bulb between terminals 2 and 4.

(a) Check that the bulb lights.

(b) Disconnect the negative {—) lead from terminal 1, and check that the bulb fades out about 8.5 seconds later.

If operation is not as specified, replace the relay.

2. INSPECT OUTSIDE HANDLE SWITCH CIRCUIT OPERATION

Connect the positive (+) lead from battery to terminal 2. Connect the negative (-) lead to terminals 3 and 6. Connect a 3.4 W test bulb between terminals 2 and 4.

Disconnect the negative (—) lead from terminal 3, and check that the bulb fades out about 8.5 seconds later.

If operation is not as specified, replace the relay.

Outside Handle Switch

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment