1. INSPECT FRONT CLUTCH PISTON
(a) Check that the check ball is free by shaking the piston.
(b) Check that valve does not leak by applying low-pressure compressed air.
2. INSPECT DISC, PALTE AND FLANGE
Check that the sliding surface of disc is not worn or burnt.
If the disc is worn or burnt, replace all discs.
Then check that the sliding surfaces of plate and flange are not worn or burnt.
If necessary, replace them.
NOTE: Do not allow the discs to dry out.
Prepare new discs by soaking them at least two hours in
Was this article helpful?