Inspection Of Front Wiper And Washer Relay

1. INSPECT INTERMITTENT OPERATION OF RELAY

(a) Connect the positive (+) lead from the battery to terminal 12. Connect the negative (-) lead to terminals 10 and 11.

(b) Inspect continuity between terminals 6 and 12 as follows.

Disconnect terminais 1,2 arvj 3

Between terminals 6 and 12

Connect terminals 10 and 11

Continuity

"Ts

Continuity

Continuity

Continuity

Continuity

Connect terminals 1. 2 and 3

Time <seconds)

Ă–etween terminals 6 and 12

Connect terminals 10 and 11

Continuity in

Continuity 1

Continuity

Continuity

Continuity

2. INSPECT WASHER CIRCUIT OF RELAY

(a) Connect the positive {+) lead from the battery to terminal 12. Connect the negative (-) lead to terminal 10.

(b) Inspect continuity between terminals 7 and 9 as follows.

<**conds> 7 and g

_ . . . Between terminals Time (seconds! 7 0nd g

Connut terminait

4 and 10 | Continuity

4 and 10 1 Continuity

over 1 j

3.7*1 t

1 No Continuity]

[No Continuity |

If continuity is not as specified, replace the relay.

1986 Mr2 Aw11 Relay Diagrams

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment