Inspection Of Front Wiper Motor

1. INSPECT THAT MOTOR OPERATES AT LOW SPEEO

(a) Disconnect the connector from the wiper motor.

(b) Connect the positive (+) lead from the battery to terminal 2. Connect the negative (—) lead to the motor body.

(c) Check that the motor operates at low speed.

2. INSPECT THAT MOTOR OPERATES AT HIGH SPEED

(a) Disconnect the connector from the wiper motor.

(b) Connect the positive (+) lead from the battery to terminal 1. Connect the negative (—) lead to the motor body.

(c) Check that the motor operates at high speed.

3. INSPECT THAT MOTOR OPERATES, STOPPING AT

RAISED POSITION

(a) Connect the positive (+) lead from the battery to terminal 2. Connect the negative <-) lead to the motor body.

(b) Operates the motor at low speed.

(c) Stop the motor operation to disconnect the battery terminals except at the raised position.

(d) Connect terminals 2 and 3.

(e) Connect the positive (+) lead from the battery to terminal 4. Connect the negative (—) lead to terminal 7.

(f) Inspect that the motor stops running at raised position after the motor operate again.

If operation is not as specified, replace the motor.

Rear Wiper and Washer Switch

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment