Inspection Of Water Temperature Gauge

1. INSPECT RECEIVER GAUGE OPERATION

(b) Disconnect the connector from the sender gauge.

(c) Check that the indicator segment is at the lowest (dimmest) point with the ignition switch at ON position.

(d) Ground the connector of the sender gauge with the connector disconnected.

(e) Check that the top segmeter flashes with the ignition switch at ON position.

2. INSPECT SENDER GAUGE OPERATION

Inspect the resistance between the terminals of the sender gauge and body ground.

Resistance: 192 - 260 ft 50°C(122°F) 65 - 89« 80°C (176° F)

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment