1. PUT LOWER INSULATOR ON REAR SUSPENSION ARM
2. PUT UPPER INSULATOR ON COIL SPRING
3. INSTALL COIL SPRING
4. CHECK POSITION OF LOWER INSULATOR
(a) Jack up the rear suspension arm.
(b) Check that the lower insulator is installed correctly, j
If the insulator is not in correct position, reinstall the coil spring.
Stabilizer Bar
5. INSTALL SHOCK ABSORBER
(a) Connect the shock absorber to the body with the nuts. Hold the shaft with a screwdriver.
Torque the nut.
(b) Connect the shock absorber to the rear suspension arm with the bolt Torque the bolt. Torque: 375 kg-cm (27 ft-lb, 37 N-m)
Stabilizer Bar
Link
Retainer
Cushion
Retainer
Cushion
Retainer
Z4987
CONNECT STABILIZER BAR END TO REAR SUSPENSION
Connect the cushion, retainer to the rear suspension arm with the nut. Torque the nut.
Z4987
INSTALL DRIVE SHAFT
Connect the drive shaft to the rear axle shaft with the nuts.
8. INSTALL BRAKE HOSE CLIPS
9. REMOVE STAND
Remove the stands and bounce the car to stabilize the suspension.
Was this article helpful?
Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.
Post a comment