Installation Of Cylinder

1. INSTALL FOLLOWING PARTS:

(a) Pad support plate

(b) Pad guide plates

(c) Anti-rattle springs

(d) Brake pads

(e) Anti-squeal shim

2. INSTALL CYLINDER

(a) Install the cylinder onto the main pin.

NOTE: Make sure that the boot end is installed into the groove of the main pin.

(b) Insert the cylinder installation bolt into the cylinder body.

(c) Install the cylinder over the brake pads.

3. TORQUE CYLINDER INSTALLATION BOLT

Torque the bolt.

4. CONNECT BRAKE LINE

(a) Connect the brake hose to the cylinder. Torque: 235 kg-cm (17 ft-lb, 23 N m)

(b) Using SST, connect brake hose to the brake tube. SST 09751-36011

5. FILL BRAKE RESERVOIR WITH BRAKE FLUID AND BLEED BRAKE SYSTEM (See page BR-7)

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment