Installation Of Extension Housing

NOTE: If necessary, install a new oil seal before installation. (See page AT-103) 1. INSTALL NEW GASKET AND EXTENSION HOUSING ON TRANSMISSION

Install the six bolts finger tight, then torque them. NOTE: The two lower bolts are shorter. Torque: 345 kg-cm (25 ft-lb, 34 N-m)

AT0?46

How Fix 2001 Celica Speed Sensor

2. INSTALL REAR SUPPORT MEMBER

(a} Install the support member to the chassis and lower the transmission to allow installation of the center bolts.

(b) Install the ground strap and rubber exhaust hanger.

3. INSTALL PROPELLER SHAFT

4. INSTALL SPEED SENSOR

5. INSTALL SPEEDOMETER DRIVEN GEAR

(a) Install a new O-ring on the shaft sleeve.

(b) Install the lock plate with a bolt and washer.

6. CONNECT SPEEDOMETER CABLE

Place the felt dust protector and washer on the end of the cable. Tighten the collar with pliers.

7. LOWER VEHICLE AND CHECK FLUID LEVEL (See page MA-13)

Start the engine, shift the selector into each gear, then check the fluid level with the transmission in "?" range. Add fluid as necessary.

CAUTION: Do not overfill.

Fluid type: ATF DEXRON' D

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment