Installation Of Gear Housing

1. INSTALL GEAR HOUSING ASSEMBLY

NOTE: Be careful not to damage the boots. Install four bolts and torque them.

2. CONNECT RETURN AND PRESSURE LINE

(a) Install the union seat.

(b) Using SST, connect the pressure line and torque it. SST 09631-22020

3. CONNECT TIE ROD ENDS

(a) Install the tie rod end set nut and torque it. Torque: 600 kg-cm (43 ft-lb, 59 N m)

(b) I nstall the new cotter pin.

2 5TM

4. INSTALL INTERMEDIATE SHAFT

(a) Install the column side first.

(b) Install the rack housing side.

(c) Install the two bolts and torque them. Torque: 350 kg-cm (25 ft-lb, 34 N m)

5. FILL WITH POWER STEERING FLUID (Seepage SR-14)

6. BLEED SYSTEM (See page SR-15)

7. CHECK FOR FLUID LEAKS

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment