Installation Of Master Cylinder

1. CLEAN OUT GROOVE ON LOWER INSTALLATION SURFACE OF MASTER CYLINDER

2. CONFIRM THAT "UP" MARK OF MASTER CYLINDER BOOT IS IN CORRECT POSITION

3. ADJUST LENGTH OF BRAKE BOOSTER PUSH ROD BEFORE INSTALLING MASTER CYLINDER

4. INSTALL MASTER CYLINDER

Install the master cylinder and gasket on the brake booster with four nuts.

5. CONNECT TWO BRAKE TUBES

Using SST, connect two brake tubes to the outlet plugs. SST 09751-36011

6. CONNECT LEVEL WARNING SWITCH CONNECTOR

7. ADJUST BRAKE PEDAL (Seepage BR-6)

8. FILL BRAKE RESERVOIR WITH BRAKE FLUID AND BLEED BRAKE SYSTEM (See page BR-7)

Brake Fluid Warning Switch

Brake Booster

Clevis Pin

Master Cylinder

I kg«cm (ft-lb, N-ml [ : Specified torque + Non-reusable part

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment