Installation Of Rear Suspension

1. INSTALL ARM

(a) Align the complete mark at the same position it was before removal.

(b) Provisionally tighten the suspension arm.

2. INSTALL COIL SPRING

3. INSTALL SHOCK ABSORBER

4. INSTALL BACKING PLATE OR DUST COVER

5. CONNECT BRAKE LINE

6. CONNECT PARKING BRAKE CABLE

7. INSTALL REAR AXLE SHAFT

8. INSTALL BRAKE DRUM OR DISC ROTOR

9. CONNECT REAR DRIVE SHAFT

10. CONNECT STABILIZER BAR TO LOWER ARM

11. LOWER VEHICLE

Lower the vehicle and bounce it several times.

12. TIGHTEN SUSPENSION ARM

Torque: Inside 1,325 kg-cm (96 ft-lb, 130 N m) Outside 1,175 kg-cm (85 ft-lb, 115 N m)

13. CHECK AND ADJUST REAR WHEEL ALIGNMENT (See page RA-3)

14. BLEED BRAKE LINE

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment