Installation Of Throttle Cable

1. INSTALL CABLE IN TRANSMISSION CASE

Be sure to push it in all the way.

2. INSTALL VALVE BODY (See page AT-34)

Painted Mark Pull lightly. (Width: 4 mm)

Rubber 8oot

Outer-Cable oflowl

Outer-Cable oflowl

Toyota Corolla Throttle Cable

3. IF THROTTLE CABLE IS NEW, PAINT MARK ON INNER CABLE

NOTE: New cables do not have a cable stopper installed.

Therefore, to make adjustment possible, paint a mark as described below.

(a) Pull the inner cable lightly until slight resistance is felt, and hold it.

(b) Paint a mark as shown, about 4 mm (0.16 in.) in width.

4. CONNECT THROTTLE CABLE

(a) Connect the cable to the throttle linkage.

(b) Connect the cable housing to the bracket on the valve cover.

5- ADJUST THROTTLE CABLE (See page AT-5)

6. INSTALL AIR CLEANER

7. TEST DRIVE VEHICLE

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Responses

  • GRACE
    How to reconnect a throttle linkage in a new celica?
    8 years ago

Post a comment