Installation Of Transmission

1. PLACE TRANSMISSION AT INSTALLATION POSITION. AND INSTALL TRANSMISSION MOUNT BOLTS

(a) Align the input shaft spline with the clutch disc, and push the transmission fully into position.

(b) Install the two set bolts of the upper transmission, and torque the bolts.

2. INSTALL ENGINE REAR MOUNTING

Install the eight bolts, and torque them. Torque: 250 kg-cm (18 ft-lb, 25 N-m)

3. INSTALL TRANSMISSION BOLTS

Install and torque the bolts. Torque: 650 kg-cm (47 ft-lb. 64 N-m)

4. INSTALL EXHAUST PIPE CLAMP BOLT

Install and torque the bolt.

5. INSTALL STARTER

Install the starter, and torque the lower bolt. Torque: 650 kg-cm (47 ft-lb. 64 N-m)

6. INSTALL CLUTCH RELEASE CYLINDER

Superior Semicircular Canal Dehiscence

miows

Land Cruiser Speedo Cable Gear

MTOJ30MT00Î1

7. CONNECT BACK-UP LIGHT SWITCH CONNECTOR

8. INSTALL SPEEDOMETER CABLE

9. INSTALL PROPELLER SHAFT

Install and torque the bolts.

10. INSTALL STEERING GEAR HOUSING (w/PS)

11. FILL WITH TRANSMISSION OIL

Oil grade: API service GL-4 or GL-5 SAE 75W-90 or 80W-90 Capacity: 2.4 liters (2.5 US qts, 2.1 Imp. qts)

12. INSTALL RADIATOR UPPER HOSE AND FILL COOLANT

13. CONNECT NEGATIVE BATTERY TERMINAL WIRE

Toyota Celica Shift Lever

14. INSTALL SHIFT LEVER

15. INSTALL CONSOLE BOX

14. INSTALL SHIFT LEVER

15. INSTALL CONSOLE BOX

Marks

16. PERFORM ROAD TEST

Check for abnormal noise and smooth operation.

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Responses

  • Sidney
    What is the thing that the speedo housing connects to on a 92 toyota pickup?
    9 years ago

Post a comment