Onvehicle Replacement Of Side Gear Shaft Oil Seal

Differential Oil Used Automobile
^ Non-reusable part Drive Shaft

1. DRAIN OUT DIFFERENTIAL OIL

2. DISCONNECT DRIVE SHAFT FROM DIFFERENTIAL

3. REMOVE CARRIER COVER

4. REMOVE SIDE GEAR SHAFT (See step 2 on page RA-23)

5. REMOVE SIDE GEAR SHAFT OIL SEAL (See step 3 on page RA-23)

6. INSTALL SIDE GEAR SHAFT OIL SEAL (See step 16 on page RA-35)

7. INSTALL SIDE GEAR SHAFT (See step 17 on page RA-36)

8. MEASURE SIDE GEAR SHAFT RUNOUT (See step 18 on page RA-36)

9. INSTALL CARRIER COVER (See step 19 on page RA-361

10. CONNECT DRIVE SHAFT (See step 4 on page RA-36»

ZSI37

11. INSTALL DRAIN PLUG AND FILL DIFFERENTIAL WITH GEAR OIL

Hypoid gear oil: w/LSD use LSD oil only

SAE 90 above — 18°C (0°F) SAE 80W or 80W - 90 at temperature below - 18°C (0°F)

Install a filler plug.

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment