Output Of Diagnostic Codes

Initial Conditions

• Battery voltage above 11 volt$.

• Throttle valve fully closed (throttle position sensor IDL points closed).

• Air conditioner switch OFF.

• Engine at normal operating temperature.

1. Turn the ignition switch to ON. Do not start the engine.

2. Using a sub-wire, short terminals of the check connector.

Check Connector

torn

Check Connector

"owe

3. Read the diagnostic code as indicated by the number of flashes of the "CHECK ENGINE" warning light.

No malfunction 0.25 second*

OFF J

0.25 seconds

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment