Power Servo Unit Operation Onvehicle Inspection

1. REMOVE COMPONENTS FROM VEHICLE

(a) Undercover

(b) Center cluster

2. RECONNECT TO CHECK CONNECTOR

3. RUN ENGINE AT IDLING

4. PLACE BLOWER CONTROL LEVER AT AUTO AIR FLOW CONTROL LEVER AT VENT TEMPERATURE CONTROL LEVER AT 77

5. CHECK BLOWER SPEED CONTROL BY SLIDING TEMPERATURE CONTROL LEVER

(a) When sliding the lever to 70, the blower speed will change in five steps.

(b) When sliding the lever to 85, the blower speed will change in four steps.

Air Intake Control Lever

6. CHECK WATER VALVE OPERATION BY SLIDING TEMPERATURE CONTROL LEVER

(a) When placing the lever at the left side fully, the water valve will close.

(b) When placing the lever at 75 or more, the water valve will open.

7. CHECK POWER SERVO STEM FOR A SMOOTH OPERATION BY SLIDING TEMPERATURE CONTROL LEVER

8. REINSTALL UNDERCOVER AND CENTER CLUSTER

CHECK

CONNEi

Temperature

Air Flow

Lever

Blower

Control Lever

Blower

Control Lever

Air Intake Control Lever

Temperature

Air Flow

Lever

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment