Remove Damping Check Ball Cooler Return Check Ball Cooler Bypass Valve And Springs

Celica Bypass Valve

TURN ASSEMBLY OVER, REMOVE SET BOLTS AND REMOVE TWO VALVE BODY COVERS AND GASKETS

REMOVE PRESSURE RELIEF VALVE

(a) Remove the bolt and retainer.

(b) Remove the spring and steel ball.

CAUTION: Cover the spring with your hand. Slowly remove the bolt, being careful not to pop out the spring.

REMOVE NO. 3 SOLENOID

(a) Remove the bolt.

(b) Remove the solenoid from the bore.

REMOVE NO. 1 AND NO. 2 SOLENOID

(a) Remove the three bolts, the solenoid and gasket.

(b) Remove the two springs from the bore.

7. REMOVE LOW COAST MODULATOR VALVE AND INTERMEDIATE MODULATOR VALVE

8. REMOVE LOCK-UP RELAY VALVE

(a) Remove the pin by pushing the sleeve.

(b) Remove sleeve with lock-up relay valve and spring.

9. REMOVE SPRING RETAINER FROM PRIMARY REGULATOR VALVE

WARNING: Highly compressed spring inside — keep away from face.

(a) Place a mark on the bevel when the retainer is positioned.

NOTE: When reassembling, position the retainer in the same position.

(b) To remove the retainer, hold the valve body face down, and press in on the valve sleeve. The retainer will drop out. Slowly relieve spring tension.

(c) Remove the sleeve, plunger, spring and primary regulator valve.

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment