Replacement Of Rear Suspension Arm Bushing

1. CHECK ARM AND BUSHING

(a) Check the bushing for wear, cracks or deterioration.

(b) Check the arm for damage, cracks or deformation.

2. REPLACE INNER AND OUTER BUSHING

(a) Cut off the flange tip of the bushing as shown in the figure.

(b) Bend the remaining portions inward with a cold chisel.

NOTE: Be careful not to damage the flange.

RAOI42

Celica Rear Suspension Bushings

(c) Bend in the flange tips and pull off the flange with a pair of pliers.

Bend the remaining flange portion so the SST can be installed to the lower arm.

(d) Using SST, press out the outer bushing from the arm.

SST 09710-22041

(09710-02040, 09710-02050, 09710-02060)

RAOI42

RAOMS

(e) Using SST, press the outer and inner bushings into the arm.

SST 09710-22041 (09751-02050,09751 02060) NOTE: Do not allow grease or oil to get on the bushings.

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment