Seat Belt

COMPONENTS

Rear Belt Celica
kg-cm (ft-lb, N m)j : Specified torque

BOO┬╗IO

FRONT SEAT BELT

[Emergency Locking Retractor (ELR) Type] 1. RUNNING TEST (IN SAFE AREA)

(a) Fasten the front seat belt.

(b) Drive the car at 10 mph (16 km/h) and make a very hard stop.

(c) Check that the belt is locked and cannot be extended at this time.

NOTE: Conduct this test in a safe area. If the belt does not lock, remove the belt mechanism assembly and conduct the following static check. Also, whenever installing a new belt assembly, verify the proper operation before installation.

2. STATIC TEST

(a) Remove the locking retractor assembly.

(b) Tilt the retractor slowly.

(c) Verify that the belt can be pulled out at a tilt of 15 degrees or less, and cannot be pulled out at over 45 degrees of tilt.

If a problem is found, replace the assembly.

OUTBOARD REAR SEAT BELT [Automatic Locking Retractor (ALR) Type]

TESTING

(a) Pull out the belt, release it slightly and then pull it out again.

(b) Verify that the belt cannot be extended further. If a problem is found, replace the assembly.

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment