Side Moulding and Garnish

COMPONENTS

Roof Drip Front Moulding

Joint Cover

Center Pillar Garnish

Roof Drip Rear Moulding

Quarter

Corner Moulding

Roof Drip Front Moulding

Joint Cover

Center Pillar Garnish

Roof Drip Rear Moulding

Quarter

Corner Moulding

Mk2 Celica Sliding

» Quarter Belt Moulding

Outside Moulding

» Quarter Belt Moulding

Outside Moulding aosos

Drip Molding

REMOVAL OF ROOF DRIP MOULDING

PULL OFF ROOF DRIP MOULDING

(a) Using SST, pull off the joint cover.

(b) Using SST, pull off the roof drip moulding from both ends.

SST 09806 30010

NOTE: Remove the moulding corners last.

Loose Drip Molding Corolla

INSTALLATION OF ROOF DRIP MOULDING

INSTALL DRIP MOULDING BY HAND

(a) Attach the upper edge of the moulding to the body flange.

Fit the moulding by tapping it by hand.

(b) I nstall the joint cover.

Replace Corolla Belt Molding

REMOVAL OF QUARTER BELT MOULDING

1. APPLY ADHESIVE TAPE TO PROTECT BODY

2, REMOVE BELT MOULDING

(a) Insert the scraper and pry loose the clips facing rearward.

(b) Pull the moulding forward and remove it.

INSTALLATION OF QUARTER BELT MOULDING

1. INSTALL CLIPS ONTO STUDS

Install the clips onto the studs.

2. INSTALL BELT MOULDING

(a) Attach the upper edge of the moulding to the clips.

(b) Fit the lower edge of the moulding by pushing with your hands.

(c) Connect the belt moulding to the corner joint by sliding it rearward.

REMOVAL OF QUARTER CORNER MOULDING

1. REMOVE QUARTER TRIM AND GARNISH

2. REMOVE CORNER MOULDING

(a) Remove the set screw.

(b) Remove the moulding.

INSTALLATION OF QUARTER CORNER MOULDING

1. INSTALL CORNER MOULDING

(a) Install the moulding.

(b) Install the screw over the cushion rubber.

2. INSTALL QUARTER TRIM AND GARNISH

Side Door Rubber Toyota Camry 2003

REMOVAL OF CENTER PILLAR GARNISH

1. REMOVE FOLLOWING PARTS:

{a) Seat belt guide

(b) Seat belt shoulder another bolt

{c) Inner garnish

2. REMOVE OUTSIDE GARNISH

Remove the two set nuts and remove the garnish.

INSTALLATION OF CENTER PILLAR GARNISH

1. INSTALL OUTSIDE GARNISH

2. INSTALL FOLLOWING PARTS:

(a) Inner garnish

(b) Seat belt shoulder anchor bolt

(c) Seat belt guide

REMOVAL OF DOOR BELT MOULDING

1. REMOVE FOLLOWING PARTS:

(b) Door weatherstrips on both ends

2. REMOVE DOOR BELT MOULDING

(a) Remove two screws from the moulding.

(b) Pry loose the clips with a scraper and remove the belt moulding.

Carina Door Mouldings

INSTALLATION OF DOOR BELT MOULDING

1. INSTALL BELT MOULDING

(a) Tap the moulding onto the clips by hand.

(b) Install the moulding with the two screws.

2. INSTALL FOLLOWING PARTS:

(a) Door weatherstrip on both ends

REMOVAL OF OUTSIDE MOULDING

1. REMOVE MOULDING MOUNTING NUT

Remove the moulding mounting nut from the rear side of the door.

2. REMOVE MOULDING

Using a scraper, pry loose the clips and remove the moulding.

INSTALLATION OF OUTSIDE MOULDING

1. BEFORE INSTALLING MOULDING, REPLACE CAPS

Remove the remaining caps on the clip installation hole of the body, and install new caps.

2. INSTALL MOULDING

(a) Install the clips to the moulding.

(b) Install the moulding onto the panel by hand.

3. INSTALL MOULDING MOUNTING NUT REMOVAL OF ROCKER PANEL MOULDING

REMOVE MOULDING

(a) Remove the three screws.

(b) Pry loose the clips with a scraper and remove the moulding.

INSTALLATION OF ROCKER PANEL MOULDING .

1. BEFORE INSTALLING MOULDING. REPLACE CAPS

Remove the remaining caps on the clip installation hole of the body, and install new caps.

2. INSTALL MOULDING BY HAND

Tap the moulding onto the clips by hand.

3. INSTALL THREE SCREWS

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Responses

  • Arnor
    How to remove supra seat belt?
    9 years ago
  • david
    How are the side moldings on 1985 supra attached?
    9 years ago
  • aristide
    How to repair drip molding from celica?
    9 years ago
  • Jeffrey
    How to remove quarter side trim celica?
    8 years ago
  • Teija Rinne
    How to fix garnish corner by screw?
    5 years ago
  • sarah
    How to replace moulding roof drip toyota yaris?
    5 years ago
  • Venanzio
    How to replace 2007 toyota avalon roof trim moldings?
    5 years ago
  • kelvin
    How to fix door moulding Toyota supra?
    4 years ago
  • KIA LIPPONEN
    How to remove toyota celica rocker?
    1 year ago
  • Rudi
    How to remove rubber trim on roof 2000 toyota celica?
    5 months ago

Post a comment