Standard piston stroke mm

If the stroke exceeds limit, the clutch pack is probably worn. If the stroke is less than the limit, parts may be misassem-bled or there may be excess ATF on the discs.

AT076*

10. INSTALL THINNER SNAP RING IN OVERDRIVE CLUTCH

DRUM

(a) Remove the overdrive clutch outer snap ring and hub to allow installation of the thinner snap ring.

(b) Compress and lower the snap ring into the groove by hand. Check that the ends of the snap ring are not aligned with one of the cutouts.

11. INSTALL HUB AND OUTER SNAP RING

Check that the ends of the snap ring are not aligned with one of the cutouts.

12. ASSEMBLE OVERDRIVE CLUTCH DRUM AND OVERDRIVE PLANETARY GEAR

Mesh the hub with the disc, twisting and jiggling the hub as required.

13. CHECK OPERATION OF ONE WAY CLUTCH

Hold the clutch drum and turn the input shaft. The input shaft should turn freely clockwise and should lock counterclockwise.

14. KEEP THRUST WASHER, THRUST BEARINGS AND RACE TOGETHER

AT076*

AT-60 AUTOMATIC TRANSMISSION - Component Groups (Overdrive Case and Brake)

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment