Components

Assist Grip Sub-assy

Roof Headlining Assy (Partial)

Back Window Glass-

Rear Door Opening

Trim Weatherstrip LH (Partial)

Roof Side Garnish Inner LH

Back Window Glass-

Rear Door Opening

Trim Weatherstrip LH (Partial)

♦ Windshield Glass Stopper

♦ Windshield Glass Stopper No.2

Back Window Moulding Outside Upper

♦ Windshield Glass Stopper

♦ Windshield Glass Stopper No.2

Back Window Moulding Outside Upper

Roof Side Garnish Inner RH

Rear Door Opening Trim Weatherstrip RH (Partial)

Package Tray Panel Assy

Roof Side Garnish Inner RH

Rear Door Opening Trim Weatherstrip RH (Partial)

Package Tray Panel Assy

Roof Side Garnish Inner LH

Separated Type Rear Seat: Room Partition Room LH

Separated Type Rear Seat: Room Partition Room RH

♦ Non-reusable part

05-619

RADIO BROADCAST CANNOT BE RECEIVED (BAD RECEPTION)

INSPECTION PROCEDURE

1 CHECK IF RADIO AUTO-SEARCH FUNCTIONS PROPERLY

(a) Check if the radio auto-search functions properly.

(1) Perform the auto-search of the radio and check that it functions normally. Standard: The radio auto-search functions properly.

CHECK AND REPLACE RADIO RECEIVER ASSY

CHECK OPTIONAL COMPONENT

(a) Check optional component (Sun shade film, telephone antenna etc.).

(1) Check whether or not any optional component is installed, such as the sunshade film and the telephone antenna, is installed. Standard: Optional component is installed.

EFFECT FROM OPTIONAL COMPONENT

CHECK ANTENNA FOR NOISE PRODUCTION

(a) Noise Check with Antenna

(1) With the ignition switch in ACC, turn on the radio and choose the AM mode.

(2) Place a tip of a screwdriver or the antenna of the antenna assembly w/ holder and check that the noise heard from the speaker.

Standard: Noise occurs.

CHECK AND REPLACE RADIO RECEIVER ASSY

05-620

4

INSPECT RADIO RECEIVER ASSY(ANTENNA)

(a) Preparation for Check

(1) Remove the antenna plug of the radio receiver assembly.

(b) Noise Check

(1) With the radio receiver assembly connector connected, turn the ignition switch to ACC.

(2) Turn on the radio and choose the AM mode.

(3) Place a flat-head screwdriver or a metal such as a thin wire on the antenna jack of the radio receiver assembly and check that the noise heard from the speaker.

Standard: Noise occurs.

CHECK AND REPLACE RADIO RECEIVER ASSY

REPLACE AMPLIFIER ANTENNA ASSY

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment