Ensure the fine lapping compound is completely washed off after rubbing

(c) Check again the braking effect of the synchronizer ring.

(d) Using a feeler gauge, measure the clearance between 3rd gear synchronizer ring back and 3rd gear spline end. Minimum clearance: 0.65 mm (0.0256 in.) If the clearance below than the minimum, replace the 3rd gear synchronizer ring, and apply small amount of the fine lapping compound on gear cone. NOTICE:

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment