Inspect Input Shaft

(a) Using a dial indicator, check the shaft runout. Maximum runout: 0.015 mm(0.0006 in.)

If the runout exceeds the maximum, replace the input shaft.

Run Out Input Shaft

(b) Using a micrometer, measure the outer diameter of the input shaft journal surface. Input shaft outer diameter:

Part

Standard outer diameter: mm (in.)

Minimum outer diameter: mm (in.)

A

24.885 - 24.900 (0.9797 - 0.9803)

24.885 (0.9797)

B

28.985 - 29.000 (1.1411 - 1.1417)

28.985 (1.1411)

C

30.985 - 31.000 (1.2198 - 1.2204)

30.985 (1.2198)

D

24.985-25.000 (0.9836 - 0.9842)

24.985 (0.9836)

If the outer diameter is below the minimum, replace the input shaft.

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment