Install Input Shaft Rear Radial Ball Bearing

(a) Using SST and a press, install the input shaft rear radial ball bearing to the input shaft. SST 09636-20010

(b) Select a snap ring from the table below that will make the thrust clearance of the input shaft rear radial ball bearing below 0.1 mm (0.0039 in.). Snap ring thickness:

Mark

Thickness: mm (in.)

Mark

Thickness: mm (in.)

0

2.29 (0.0901)

3

2.47 (0.0972)

1

2.35 (0.0925)

4

2.53 (0.0996)

2

2.41 (0.0948)

5

2.59 (0.1019)

(c) Using a brass bar and a hammer, tap in the snap ring. NOTICE:

Take care not to damage the journal surface of the snap ring.

(c) Using a brass bar and a hammer, tap in the snap ring. NOTICE:

Take care not to damage the journal surface of the snap ring.

27. INSPECT 3RD GEAR RADIAL CLEARANCE

(a) Using a dial indicator, measure the 3rd gear radial clearance.

3rd gear radial clearance:

27. INSPECT 3RD GEAR RADIAL CLEARANCE

(a) Using a dial indicator, measure the 3rd gear radial clearance.

3rd gear radial clearance:

Standard clearance: mm (in.)

Maximum clearance: mm (in.)

KOYO made

0.015 - 0.058 (0.0006 - 0.0023)

0.058 (0.0023)

NSK made

0.015 - 0.056 (0.0006 - 0.0022)

0.056 (0.0022)

If the clearance exceeds the maximum, replace the gear, needle roller bearing or shaft.

28. INSPECT 4TH GEAR RADIAL CLEARANCE

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment