Light Control Rheostat

(a) Connect the connector to the rheostat and inspect the wire harness side connector from the back side as shown in the table below. Standard:

Tester connection

Switch operation

Specified condition

1 - 3

Maximum position

Below 1 V

1 - 3

Minimum position

10 to 14 V

3 - 7

OFF

10 to 14 V

3 - 7

ON

Below 1 V

(b) Inspect illumination operation.

(1) Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 3, then check that the illumination comes on.

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment