Wear the gloves, because the cutting surface of the seat back frame and seat adjuster may injure your hand.
Tape the screwdriver tip before use when prying parts.
1. DISCONNECT BATTERY NEGATIVE TERMINAL CAUTION:
Wait for 90 seconds after disconnecting the battery terminal and disconnect the airbag connector.
2. REMOVE FRONT SEAT
(a) Remove the headrest.
(b) Remove the seat track covers and 4 bolts.
(c) Slide the seat to the most rear position.
(d) Disconnect the connector(s) under the seat.
(e) Remove the seat.
Be careful not to damage the body.
3. REMOVE SEPARATE TYPE FRONT SEAT BACK ASSY
(a) Remove the bolt, washer and seat belt inner.
(b) Remove the seat cushion shield inner.
(c) Using a screwdriver, remove the reclining adjuster release handle.
(d) Remove the seat cushion shield outer.
Disconnect the airbag wire under the seat.
(f) Remove the hog rings, 4 bolts and seat back.
4. REMOVE SEPARATE TYPE FRONT SEAT BACK COVER
(a) Remove the hog rings and turn up the seat back cover.
Using a screwdriver, disconnect the clip.
(c) Remove the headrest supports, seat back cover and seat back pad.
Was this article helpful?