With terminal retainer or secondary locking device

1. PREPARE THE SPECIAL TOOL

HINT: To remove the terminal from the connector, please construct and use the special tool or like object shown on the left.

2. DISCONNECT CONNECTOR

Sw20 Left Plug

3. DISENGAGE THE SECONDARY LOCKING DEVICE OR

TERMINAL RETAINER.

(a) Locking device must be disengaged before the terminal locking clip can be released and the terminal removed from the connector.

(b) Use a special tool or the terminal pick to unlock the secondary locking device or terminal retainer.

NOTICE:

Do not remove the terminal retainer from connector body.

Terminal Retainer

Terminal Retainer

[Retainer at Full Lock Position]

Terminal

Stopper Retainer

Terminal

Stopper Retainer

Example: Secondary

[A] For Non-Waterproof Type Connector

HINT : The needle insertion position varies according to the connector's shape (number of terminals etc.), so check the position before inserting it.

"Case 1"

Raise the terminal retainer up to the temporary lock position.

"Case 2"

Open the secondary locking device.

[B] For Waterproof Type Connector

HINT: Terminal retainer color is different according to connector body.

Example:

Terminal Retainer : Connector Body Black or White : Gray Black or White : Dark Gray Gray or White : Black

Blank Totota Wire Terminal

"Case 1"

Type where terminal retainer is pulled up to the temporary lock position (Pull Type).

Insert the special tool into the terminal retainer access hole (^Mark) and pull the terminal retainer up to the temporary lock position.

HINT: The needle insertion position varies according to the connector's shape (Number of terminals etc.), so check the position before inserting it.

"Case 2"

Type which cannot be pulled as far as Power Lock insert the tool straight into the access hole of terminal retainer as shown.

Retainer at Full Lock Position

Retainer at

Temporary Lock Position

Push the terminal retainer down to the temporary lock position.

Position Locking Device

(c) Release the locking lug from terminal and pull the terminal out from rear.

4. INSTALL TERMINAL TO CONNECTOR

(a) Insert the terminal. HINT:

1. Make sure the terminal is positioned correctly.

2. Insert the terminal until the locking lug locks firmly.

3. Insert the terminal with terminal retainer in the temporary lock position.

(b) Push the secondary locking device or terminal retainer in to the full lock position.

5. CONNECT CONNECTOR

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Responses

  • Christopher
    How to disconnect connectors toyota?
    8 years ago
  • jonne
    How to unlock the wire from secondary locking device?
    8 years ago
  • faruz kinfe
    How remove the terminal retainer on my tacoma?
    2 years ago
  • luca
    How to remove wire with terminal retainer?
    8 months ago

Post a comment