Lower Ball Joint Assy Front Lh Replacement

HINT:

COMPONENTS: See page 26-3

Toyota Corolla Ball Joint Replacement

1. INSPECT LOWER BALL JOINT ASSY FRONT LH

(a) Jack up front side of the vehicle.

(b) Check the rattle of the lower ball joint assy front LH

2. REMOVE FRONT WHEEL

3. REMOVE FRONT AXLE HUB LH NUT(See page 30-6) SST 09930-00010

4. DISCONNECT SPEED SENSOR FRONT LH (W/ ABS)(See page 30-6)

5. SEPARATE TIE ROD END SUB-ASSY LH(See page 30-6)

SST 09628-62011

6. SEPARATE FRONT SUSPENSION ARM SUB-ASSY LOWER NO.1 LH(See page 30-6)

7. SEPARATE FRONT AXLE ASSY LH(See page 30-6)

Sst 09628 62011

8. REMOVE LOWER BALL JOINT ASSY FRONT LH

(a) Remove the cotter pin and castle nut.

(b) Using SST, remove the lower ball joint assy from the steering knuckle LH.

SST 09628-62011

09628 62011

9. INSPECT LOWER BALL JOINT ASSY FRONT LH

(a) As shown in the illustration, flip the ball joint stud back and forth 5 times, before installing the nut.

(b) Using a torque wrench, turn the nut continuously at a rate of 3 - 5 seconds per 1 turn and take the torque reading on the 5th turn.

Turning torque:

Author- Dntp- 1248

10. INSTALL LOWER BALL JOINT ASSY FRONT LH

(a) Install the lower ball joint assy front LH to the steering knuckle LH, tighten the castle nut. Torque: 103 Nm (1050 kgfcm, 76 ftlbf)

(b) Install a new cotter pin.

11. INSTALL FRONT AXLE ASSY LH(See page 30-6)

12. INSTALL FRONT SUSPENSION ARM SUB-ASSY LOWER NO.1 LH(See page 30-6)

13. INSTALL TIE ROD END SUB-ASSY LH(See page 30-6)

14. INSTALL SPEED SENSOR FRONT LH (W/ ABS)(See page 30-6)

15. INSTALL FRONT AXLE HUB LH NUT(See page 30-6) SST 09931-00020

16. INSTALL FRONT WHEEL

Torque: 103 Nm (1,050 kgfcm, 76 ftlbf)

17. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT(See page 26-5)

18. CHECK ABS SPEED SENSOR SIGNAL (W/ ABS)(See page 05-297)

Was this article helpful?

+1 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Responses

  • Furuta
    How to change the ball joint on a toyota corolla 2004?
    8 years ago

Post a comment