5 Screw the switch into the pedal bracket and loosely refit the locknut.
6 Continue to screw in the switch until the plunger makes light contact with the pedal, then rotate the switch anti-clockwise one complete turn. Tighten the locknut.
7 Check the clearance between the switch and the pedal (see illustration).
8 Reconnect the wiring connector, and check the operation of the stop-lights. Refit the metal plate and facia panel.
19.8 Remove the clamp retaining bolt (right arrows), lever bushing out of the bracket (centre arrows) and disengage the cable from the equaliser (left arrows)
Was this article helpful?