Remove Spider Bearings

(a) Using SST, push out the bearing from the propeller shaft. SST 09332 25010

NOTE: Sufficiently raise the part indicated by A so that it does not come into contact with the bearing.

(b) Clamp the bearing outer race in a vise and tap off the propeller shaft with a hammer. NOTE: Remove the bearing on the opposite side in the same procedure.

(c) Install the two removed bearing outer races to the spider.

(d) Using SST, push out the bearing from the yoke. SST 09332 25010

(e) Clamp the bearing outer race in a vise and tap off the yoke with a hammer. NOTE: Remove the bearing on the opposite side in the same procedure.

4. INSTALL SPIDER BEARINGS

(a) Apply MP grease to the spider and bearings. NOTE: Be careful not to apply too much grease.

lb) Align the marks on the yoke and shaft.

(c) Fit the new spider in the yoke.

(d) Using SST, install the new bearings on the spider. SST 09332 25010

(e) Adjust both bearings so that the snap ring grooves are at maximum and equal widths.

5. INSTALL SNAP RINGS

(a) Install two snap rings with the same thickness which will allow 0 - 0.05 mm (0-0.0020 in.) axial play. NOTE: Do not reuse the snap rings.

Snap ring sizes

Color

Thickness mm (inj

None Brown Blue None

2.375 - 2.425 (0.0935 - 0.09551 2.425 - 2 475 (0.0955 - 0.0974) 2.475 - 2.525 (0.0974 - 0.09941 2.526 -2.575 (0.0994 - 0.10141

5. INSTALL SNAP RINGS

(a) Install two snap rings with the same thickness which will allow 0 - 0.05 mm (0-0.0020 in.) axial play. NOTE: Do not reuse the snap rings.

Snap ring sizes

(b) Using a hammer, tap the yoke until there is no clearance between the bearing outer race and snap ring.

Was this article helpful?

+1 0

Post a comment