Alternator Terminals

Toyota's high-speed alternator has the following terminals: "B", "IG", "S", "U', and "17".

When the ignition switch is "on," battery current is supplied to the regulator through a wire connected between the switch and terminal "IG". When the alternator is charging, the charging current flows through a large wire connected between terminal "B" and the battery. At the same time, battery voltage is monitored for the MIC regulator through terminal "S". The regulator will increase or decrease rotor field strength as needed. The indicator lamp circuit is connected through terminal "U'. If there is no output, the lamp will be lit. The rotor field coil is connected to terminal "P, which is accessible for testing purposes through a hole in the alternator end frame.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment