L

6-229

6-218

1.

Injection Pump

2.

Oil Pipe

3.

Fuel Hose

4.

Control Rod

5.

Vinyl Hose

6.

Injection Pipe

7.

Fig. 6-216

Make sure that the No.1 cylinder piston is at 10° BTDC/Compression before installing the injection pump.

Fig. 6-217

Fig. 6-217

Mating M

Make sure that the No.1 cylinder piston is at 10° BTDC/Compression before installing the injection pump.

Mating M

Align the mating marks on the injection pump spiine shaft and timer drive shaft when installing the Injection pump.

Coat MP grease on the splines.

Align the mating marks on the injection pump spiine shaft and timer drive shaft when installing the Injection pump.

Coat MP grease on the splines.

Toyota Grease

Fig. 6-219

Fig. 6-219

A Bleed the air from fuel system after installation is completed.

(1) Bleed the air from fuel filter by operating priming pump.

Fig. 6-220

Fig. 6-220

(2) Bleed the air from injection pump by operating priming pump.

Fig. 6-221

Fig. 6-221

(3) Loosen all union nuts of the injection pipe at nozzle holder side.

Fig. 6-222

Fig. 6-222

START

(4) Turn the engine with the accelerator pedal depressed all the way.

Fig. 6-223

Fig. 6-223

(5) Bleed the air by cranking the engine and force out the fuel from injection pipe.

Start the engine and inspect all pipe lines for fuel leaks.

Fig. 6-224

Fig. 6-224

Adjust the engine idle speed and the maximum speed after installation is completed. ( 1 ) Warm up the engine. (2) Check the engine idle speed.

Idle speed 625 - 675 rpm

Adjust the engine idle speed and the maximum speed after installation is completed. ( 1 ) Warm up the engine. (2) Check the engine idle speed.

Idle speed 625 - 675 rpm

Fig. 6-225

Fig. 6-225

(3). Adjust the idle speed to specification by turning the stop plate adjusting screw.

Fig. 6-226

Fig. 6-226

(4) Make sure that the throttle valve is fully open when the accelerator pedal is depressed all the way.

(5) Make the full open adjustment through the full throttle adjusting bolt or accelerator pedal stop bolt.

Fig. 6-228

Fig. 6-228

Fig. 6-229

(6) Check the engine maximum speed when the accelerator pedal is depressed all the way.

Maximum speed 4050 — 41000 rpm

(7) If the maximum speed is not within specification, adjust by turning the adjusting screw of the injection pump.

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Responses

  • Emmie
    How to bleed air from landcruiser injector pump?
    8 years ago

Post a comment