Bleeding Of Clutch System

NOTE: If any work is done on the clutch system, or if air is suspected in the clutch lines, bleed the system of air. CAUTION: Do not let brake fluid remain on a painted surface. Wash it off immediately.

1. FILL CLUTCH RESERVOIRS WITH BRAKE FLUID

Check the reservoir after bleeding. Add fluid if necessary.

2. CONNECT VINYL TUBE TO RELEASE CYLINDER BLEEDER PLUG

Insert the other end of the tube in a half-filled container of brake fluid.

3. BLEED CLUTCH LINE

(a) Slowly pump the clutch pedal several times.

(b) While having an assistant press on the pedal, loosen the bleeder plug until fluid starts to runout. Then close the bleeder plug.

(c) Repeat this procedure until there are no more air bubbles in the fluid.

(d) Torque the bleeder plug. Torque: 110 kg-cm (8 ft-lb, 11 N m)

Was this article helpful?

0 0

Responses

  • SEBHAT
    How to bleed a clutch on a fj40 land cruiser?
    8 years ago
  • Eric
    How to bleed toyota landcruiser clutch system?
    8 years ago

Post a comment