Inspect Rear Axle Shaft

(a) Check for wear or damage.

(b) Check the runout of axle shaft. Maximum runout: 0.8 mm (0.031 in.)

2. INSPECT OIL SEAL AND BEARING FOR WEAR OR DAMAGE

If the oil seal and bearing is damaged or worn, replace it.

3. REPLACE OIL SEAL AND BEARING (a) Using SST, remove the oil seal. SST 09308-00010

(b) Using SST, remove the bearing. SST 09514-35011

(c) Apply MP grease to the bearing.

(d) Using SST, drive in the bearing. SST 09608-20011

(e) Using SST, drive in the oil seal. SST 09608-20011

(f) Apply MP grease to the oil seal lip.

Was this article helpful?

0 0

Post a comment