Door Panel Hinge

REMOVAL

Remove the parts in the numerical order shown in the figure.

1. Lift Door Hinge

2. Lift Door Panel

3. License Light

4. Inside Handle

5. Gate Door Stay

6. Gate Door Stay

7. Gate Door Hinge

8. Gate Door Panel

INSTALLATION

Install the parts in the numerical order shown in the figure.

Fig. 12-100

Gate Hinges Toyota

1. Gate Door Hinge

2. Gate Door Panel

3. Gate Door Stay

4. Gate Door Stay

5. Inside Handle

6. License Light

7. Lift Door Hinge 8 Lift Door Panel

ADJUSTMENT

Check the door framework.

Fig. 12-103

Fig. 12-103

Fig. 12-104

Loosen the body hinge bolts and adjust the back door left-right and up-down positions.

Loosen the door hinge bolts and adjust the left-right and forward-backward positions of the door.

Fig. 12-105

BACK DOOR STRIKER ADJUSTMENT SECTION Fig. 12-96 & 12-97

Adjust the door lock striker

SWING OUT DOOR RIGHT BACK DOOR LOCK

REMOVAL

Remove the parts in the numerical order shown in the figure.

Fig. 12-106

1.

Door Inside Handle Bezel

7.

Door Outside Handle

2.

Door Trim

8

Door Lock Cylinder

3

Door Inside Handle & Link

9

Door Lock Striker

4

Service Hole Cover

10

Door Pull Handle

5

Door Lock

11.

Right Door

6.

Door Inside Lock Lever

Fig. 12-107

Fig. 12-108

Insert a screwdriver between the door panel and retainers and pry out.

Tape the screwdriver before use.

Fig. 12-108

Fig. 12-109

MP Grease

Remove the inside handle.

Remove the inside handle.

INSPECTION

1. Operation of moving parts

2. Lubrication of lock sliding parts

INSTALLATION

Install the parts in the numerical order shown in the figure.

Fig. 12-110

Toyota Cruiser Wood Panels

1.

Right Door

7

Door Lock

2.

Door Pull Handle

8

Service Hole Cover

3.

Door Lock Striker

9

Door Inside Handle & Link

4

Door Lock Cylinder

10

Door Trim

5

Door Outside Handle

1 1

Door Inside Handle Bezel

6

Door Inside Lock Lever

Fig. 12-111

Seal the service hole cover with adhesive.

Fig. 12-112

Fig. 12-112

ADJUSTMENT

Outside Handle

1. Check the outside handle play.

Control link play: 0.5 - 1.0 mm (0.020 - 0.039 in.)

2. Adjust the control link play.

Fig. 12-113

Fig. 12-113

Inside Handle

1. Loosen the screws.

2. Move the handle forward to the point where strong resistance is felt.

3. Turn backward 0.5 - 1.0 mm (0.020 -0.039 in.) and tighten.

Fig. 12-114

Fig. 12-114

Door Lock Striker

Open and close the door by the outside handle and adjust so that the door lock does not contact the striker.

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment